Here’s the necessary Odin tools that can be use for flashing stock firmwares manually. All you need is grab the desired Odin version that will worked to your phones.
| Odin Flashers | Download link1 | Download link2 |
| Odin3_v1.85 | link | link |
| Odin3_v3.04 | link | link |
| Odin3_v3.07 | link | link |
| Odin3_v3.09 | link | link |
Using Odin
Most stock firmwares comes in single file (.tar.md5) format and can be only loaded in Odin’s PDA or AP field. You must also install the USB drivers in order for Odin to work. USB drivers
can be installed directly into your computer by simply unzipping the
downloaded file then simply run as administrator to completely install
it.
Odin Download Mode
To be able to communicate your phone with your computer while using Odin flashers, your phone must be set into ‘download mode’. Mostly Samsung
Android devices can be set in download
mode by turning it off then simply by pressing volume down, home and
power button at the same time. Then a warning message appear that
prompts you to press the volume up button to continue. Once in download
mode you may then simply connect your device on to your computer using
the supplied USB cable.
Failures of using Odin
Odin errors and flashing failures may only caused by a bad USB cable
connection between your computer serial ports. So while during the
flashing of stock firmware process,
you must ensure that you have a fully working USB cable and a good
computer USB serial ports. You may also see to it that you have properly
installed the USB drivers.
No comments:
Post a Comment